Spent a little time each night this week cutting foam inclines and risers for the module. Tried a couple of different approaches for the inclines. I’m much happier with the 1.5″ incline strip that I cut into 2″ blocks than the strip with notches to bend. Both will work so I glued them down rather than repeat cutting the notched one. Took advantage of a snow day to have Josiah help clean up the room and lay the track back on the foam.I even took the time to level in some older, undecorated modules. Everything fits together well, just need to do some drilling for turnout control and power. I may go with loose wires to test run a few laps.